Phone Charging Station

2017

We had this corporate giveaway phone charging station that you put your phones on and ran your charging cables through.  But it also had these little mail slots and storage things that just always collected junk.  It was ugly, and it was a mess. So when I saw this little beauty slice of kingswood at our local specialty wood shop I knew what I wanted to do.

Compared to the Lazy Susan project, this was pretty quick.


Slicing off a chunk, and planning for the pegs to hold the phones.  Obligatory test chunk on the side.
Pegs are in !

Cutting some angled feet from some leftover wood from the Game Table.  The holder will have to hover a bit over the table so that the cables can loop in from underneath.
Feet attached !  Also one of the few views where you can see the live edge of the board.
Sealed and in-service !  No stains were used – the wood just looks that good.

Leave a Reply

Your email address will not be published. Required fields are marked *